Comments are closed.
Upgrading the Capacity (Part II)
March 10th, 2010
After successfully plugging out the old IDE hard disk you want to replace (if there is any), you are now ready to plug in your new addition or upgrade.
When you plug in the new IDE hard disk, make sure that the jumpers are in the right configuration and the pins are in the proper orientation (master or slave). Check the alignment notch to guide you with the pins and the jumper settings on the back of the IDE hard disk or product manuals to help you verify the jumper configuration.
Next, you now connect the IDE and power cables. Then slide the new IDE hard disk into the slot where the old one was or any empty slot on your case.